Cheap, Aluminum Light, weight Folding, RC Plane Holding / Work Stand
Build it out of items you can find for cheap or even free. And only takes about an Hour to asemble it.
I did not think this would really grab much positive attention, but after seeing it, many of our RC Flyers are either making one or plan to and suggested I write it up for the club newsletter and others.
Not much to write up.
Finished Stand. Note the Foam handles that came on both the walker and the crutches serves as a soft support for the plane. The only protective items I added was some 3M heavy rubber type heat shrink tubing to the top ends of the crutches where I had cut off the armpit supports from the crutches. |
I removed the adjustable tips from the bottom of the crutches and as mentioned cut off the the airpit supports from the crutches. Then using sheet metal screw fastened the crutches to the sides of the walker. |
This picture shows the completed assembly with one side of the walker folded in. |
This pictures shows it all folded up and ready to store go into the car. Note I left the bottom adjustable legs on the walker so I could adjust the overal height to be higher for standing and lower for sitting. |
The Stand in use at the field. Note that the open side of the walker makes it easy to pull a chair up and sit to work with the plane suspended over your leggs. |
Any Question or comments. Contact me at;
|